Water Heater Maintenance: Extend Its Life by Years
Most water heaters fail prematurely due to neglect. Two simple annual tasks can add years to your unit and prevent a costly emergency.
A standard tank water heater has a lifespan of 8 to 12 years. Many units fail well before that mark — not because of a manufacturing defect, but because of sediment buildup and a neglected anode rod. Both problems are easy and inexpensive to address with annual maintenance. Ignoring them leads to reduced efficiency, higher energy bills, and eventually a failed unit that floods your utility room.
How Sediment Destroys Water Heaters
The Inland Empire has hard water — water with a high concentration of dissolved minerals, primarily calcium and magnesium. Every time your water heater heats water, those minerals precipitate out of solution and settle to the bottom of the tank as sediment.
Over time, sediment accumulates into a thick layer at the bottom of the tank. This layer insulates the water from the burner, forcing the burner to run longer and work harder to heat the same amount of water. You will notice this as a popping or rumbling sound from the tank — that is the sound of water trapped beneath the sediment layer boiling and escaping. The result is higher gas or electric bills, reduced hot water capacity, and accelerated wear on the tank lining.
How to Flush Sediment
Flushing your water heater once a year removes accumulated sediment and restores efficiency. The process involves connecting a garden hose to the drain valve at the bottom of the tank and allowing the water to run until it flows clear. If your water heater has not been flushed in several years, the sediment may have hardened, in which case a plumber should perform the flush to avoid damaging the drain valve.
The Anode Rod: Your Water Heater's Sacrificial Protector
The anode rod is a metal rod — typically magnesium or aluminum — suspended inside the tank. It works through a process called electrolytic action: it corrodes preferentially so that the steel tank walls do not. Without a functioning anode rod, the tank itself begins to rust from the inside out.
Anode rods need to be inspected every two to three years and replaced when they have corroded down to the wire core. A replacement rod costs $20 to $50 and takes a plumber about 30 minutes to install. A new water heater costs $800 to $2,000 or more, plus installation. The math is straightforward.
Signs Your Water Heater Needs Attention
- Rusty or discolored hot water — indicates internal corrosion; the tank may be near the end of its life
- Rotten egg smell from hot water — caused by sulfur-reducing bacteria reacting with a depleted magnesium anode rod; replacing the rod with an aluminum/zinc rod typically resolves this
- Popping or rumbling sounds — sediment buildup
- Water pooling around the base of the tank — a sign of a failing tank; replace immediately
- Inconsistent hot water or longer recovery times — sediment reducing efficiency or a failing heating element
When to Repair vs. Replace
If your water heater is under eight years old and the issue is sediment or a failed anode rod, repair and maintenance make sense. If the tank is leaking, the unit is more than ten years old, or you are experiencing repeated failures, replacement is the more economical choice. Tankless water heaters are worth considering at replacement time — they heat water on demand, never run out of hot water, and have a lifespan of 20 years or more.
Schedule your annual water heater maintenance with AAA Plumbing, Heating & Air Conditioning. Call (951) 684-3333 or book online. We serve the entire Inland Empire including Riverside, San Bernardino, Ontario, Fontana, Corona, Norco, and Moreno Valley.
Explore Topics
Written by
AAA Plumbing, Heating & Air Conditioning
Content creator and writer sharing insights and stories.