plumbing

Whole-House Repiping: What to Expect and When You Need It

Aging galvanized or polybutylene pipes can contaminate your water and cause leaks throughout your home. Here is what repiping involves.

A
AAA Plumbing, Heating & Air Conditioning
••4 min read
Whole-House Repiping: What to Expect and When You Need It

Most homeowners never think about the pipes inside their walls until something goes wrong. But if your home was built before 1990, the pipes that carry water to every faucet, shower, and appliance may be approaching the end of their functional life — or may have already passed it.

Pipe Materials and Their Lifespans

Galvanized Steel (Pre-1960s to 1970s)

Galvanized steel pipes were the standard in residential construction for decades. They are coated with zinc to resist corrosion, but that coating degrades over time. As the zinc wears away, the steel beneath begins to rust. The rust accumulates inside the pipe, progressively narrowing the interior diameter and reducing water pressure. It also flakes off and enters your water supply, causing discoloration and a metallic taste. Galvanized pipes that are 40 or more years old are typically past their service life.

Polybutylene (1978–1995)

Polybutylene was used extensively in residential construction from the late 1970s through the mid-1990s because it was inexpensive and easy to install. It was later discovered that polybutylene reacts with chlorine and other oxidants present in municipal water supplies, causing the pipe to become brittle and crack from the inside out. Failures are often sudden and can cause significant water damage. If your home has polybutylene pipes — identifiable by their gray color — replacement is strongly recommended regardless of their current condition.

Copper

Copper pipes installed correctly have a lifespan of 50 years or more. However, copper is susceptible to pinhole leaks caused by aggressive water chemistry, and older copper installations may have lead-based solder at the joints, which is a health concern. Copper remains the gold standard for repiping when budget allows.

PEX (Cross-Linked Polyethylene)

PEX has become the most common material for residential repiping over the past two decades. It is flexible, resistant to freezing, does not corrode, and is significantly less expensive than copper. PEX is approved by all major plumbing codes and carries a 25-year manufacturer warranty in most cases.

Signs You May Need Repiping

  • Chronically low water pressure throughout the house, not just at one fixture
  • Discolored water — brown, orange, or red tints indicate rust inside the pipes
  • Frequent leaks at multiple locations in a short period of time
  • Visible corrosion on exposed pipes in the garage, crawlspace, or utility room
  • Lead solder at joints in homes built before 1986

What the Repiping Process Involves

A whole-house repipe typically takes one to three days depending on the size of the home and the accessibility of the existing pipes. The process involves:

  1. Assessment — A licensed plumber inspects the existing system, identifies the pipe material, and maps the supply lines.
  2. Access — Small access holes are cut in drywall at strategic locations to route the new pipes. Minimally invasive techniques reduce the number of holes required.
  3. Installation — New supply lines are run throughout the home. All fixtures are connected and tested.
  4. Patching — Drywall is patched and textured. Most plumbing companies coordinate with a drywall contractor or include patching in the scope of work.

Water is typically off for only a few hours during the actual pipe replacement. Most families can remain in the home throughout the process.

The Cost of Waiting

A single pinhole leak in a copper pipe or a crack in a polybutylene line can cause thousands of dollars in water damage. If your home has aging pipes and you are experiencing any of the warning signs above, a repiping estimate is a worthwhile investment. The cost of repiping is almost always less than the cost of repairing water damage from a catastrophic pipe failure.

Call AAA Plumbing, Heating & Air Conditioning at (951) 684-3333 to schedule a pipe inspection and repiping estimate. We serve Riverside, San Bernardino, Ontario, Fontana, Corona, Norco, and Moreno Valley.

Explore Topics

#repiping#galvanized pipes#copper pipes#PEX plumbing#Riverside plumber
A

Written by

AAA Plumbing, Heating & Air Conditioning

Content creator and writer sharing insights and stories.